Aircare EA1407 Manuel du propriétaire télécharger pdf (Page 8)

FAN SPEED

This humidifier is equipped with a 3-speed fan control. Initially

pressing the speed button will display the current speed setting.

Each push of the speed button advances the mode through the

settings of (HIGH) F3, (MEDIUM) F2 , (LOW) F1 and A (AUTO).

HUMIDITY CONTROL

This button allows you to adjust the humidity to suit your needs.

This humidifier will automatically cycle on and off as required to

maintain the selected setting.

The readout displays both actual (ROOM) and desired (SET)

humidity percentage (%) settings when humidity control button is pressed. The ROOM

readout has a range of 20% to 90% RH. If the room humidity level is equal to or less

than 20% the display will show a flashing 20. When above 90%, two bars (- -) will flash

on the display and the fan will stop.

The SET readout has a range of 25% to 65% RH and is adjusted in increments of 5%.

Initially depressing the humidity button will display the current humidity setting. Each

additional press of the button increases the setting by 5%. A SET point of 65% RH

operates the humidifier continuously until it reaches above 90%, at which time the fan

will turn off. The humidistat that senses the readings is located on the power cord.

Ensure that it is free from obstruction.

REFILL DISPLAY

For maximum run time both the bottle and the base should be filled.

When both the bottle and the base are empty, the display alternates

the room humidity reading and “F” (FILL), indicating additional

water is required.

CHECK FILTER INDICATOR

The ability of any humidifier to efficiently supply humidity output

relies heavily on the condition of the wick (filter). As the wick loads

with impurities it gradually loses its wicking capability. When this

happens, moisture output is reduced and the humidifier has to work

longer to satisfy the selected setting. This humidifier has a check

filter reminder timed to appear after 720 hours of operation. When the display shows

an alternating “CF” and “room humidity” setting at 5 second intervals it is a reminder

to check the filter (wick) condition.

NOTE: Some areas have high water mineral content causing the need for more

frequent wick changes.

Reset the Check Filter “CF” function each time you replace a wick by unplugging the

unit from the power source for 1-2 minutes, then plug it in again.

Refer to “Replacement of Wick” section below. If a build-up of deposits or severe

discoloration is evident, replace the wick to restore maximum efficiency.

CONTROL LOCK FEATURE

To avoid unwanted tampering with the humidifier settings the

controls can be locked.

CONTROL LOCK ACTIVATION PROCEDURE

After the humidifier functions have been set up, hold the power

button down for 5 seconds. The display will show “CL” for 2 seconds; release the

power button and the control will resume the display of the room humidity. The

humidifier will continue to function with the locked in settings. If buttons are operated

while “CL” is active, the “CL” is displayed and settings are unaffected.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Aircare EA1407 Manuel du propriétaire Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Humidificateurs Aircare EA1407