Aircare EA1407 Manuel du propriétaire télécharger pdf (Page 13)

13

Troubleshooting

Trouble

Probable Cause

Remedy

Digital display not

illuminated.

• No Power.

• Power button has not been

depressed.

• Check 120 volt power source.

• Press power button once to

turn on.

Fan not operating (digital

display is illuminated).

• ROOM humidity level is not 3%

or more below SET humidity

level.

• Reservoir is empty.

• Raise SET humidity level if desired.

• Increase fan speed.

• Fill humidifier with water.

Fan running continuously.

• Float is obstructed.

• SET humidity level is

65%.

• ROOM humidity level

has not reached 1% or

more above SET

humidity level.

• Free float from obstruction.

• A SET humidity percentage of 65%

operates fan continuously. Adjust

SET level between 25% - 60%.

• Continue to run until desired

humidity level is achieved. This

may take up to 48 hours initially.

Poor evaporation of water.

• CHECK FILTER (CF) message

flashing.

• Mineral buildup on filter (wick).

• Change to a fresh new wick

NOTE: Local water varies from area

to area and under certain conditions

minerals will build up more rapidly in the

wick.

•Unplug unit for 1-2 minutes to reset

CF function

Neither bottle emptying. • Bottle cap plunger

missing post in bottom

of cabinet

• Dirty wicks.

• Check orientation of bottles.

Reposition so that bottle cap

plunger (stem) is depressed by

post in bottom of cabinet.

• Change to fresh new wick

(HDC12).

Bottles continue to empty

after complete filling.

• Air is entering water

bottle.

•Check “Side-Fill Caps” and valve

assembly caps to ensure tightness.

• Check for leak in water bottle.

• Ensure gaskets for “Side Fill Caps”

are in place.

Left bottle not emptying. • Right bottle contains

water.

•The humidifier is designed so that

right bottle empties first.

• Ensure unit is level - Install caster

pads on front casters, as needed.

Bottle empties completely

• This is normal for initial filling

• Refill bottle for maximum

run time.

Refill display “F” is on

before bottles are empty.

• Unit is not set up on a

level surface. (Float

will not sense water at

the front of the

cabinet.)

• Position unit level. (Some carpet padding

may allow unit to sit lower in the front than

rear with the additional weight of water

bottles in the front of the cabinet. Install

caster pads under front casters.

“CF” message does not

appear even when wick is

dirty or humidifier

performance is clearly

reduced.

• Loss of power or a

power failure has caused the

CF message to prematurely

reset.

• Replace wick.

Display blinks or fan moves

slightly when humidifier is

plugged in.

Normal

• No action required.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Commentaires sur ces manuels

Pas de commentaire