Aircare EA1407 Manuel du propriétaire télécharger pdf (Page 6)

2. To fill, remove the “Side-Fill Cap” and place the opening under a water faucet (the

bottle should fit under a four-inch clearance faucet).

3. Fill with recommended mixture of cold water and Bacteriostat (if necessary) only.

Solid debris could make the valve leak. Install the “Side-Fill Cap” by twisting

clockwise. Hand tighten only.

NOTE: Both bottle caps have rubber washers in them. Do Not Remove.

4. Check for possible leaks by performing the following:

a. Grasp bottle handle and hold the bottle upright over a sink.

b. Inspect the bottom valve for leaks.

c. Press up on the valve cap plunger for about one second to let out a little water.

d. Release the plunger.

e. Listen for air bubbles. Look for leaks around the“Side-Fill Cap”.

f. If you hear air bubbles or see leaks, retighten the “Side-Fill Cap” and repeat Steps a-e.

5. Wipe off excess water from the bottle.

6. Position the water bottle back into the

unit by grasping the water bottle

handle and lowering it gently into the

cabinet until the bottle sits on pads at

bottom of cabinet. The “Side-Fill Cap”

must be facing the rear of the cabinet.

When positioned properly, the plunger

will open and water will flow into the

cabinet. The water level will

automatically remain at approximately

1/2” until the bottles are empty. Allow

the wick to saturate for 30 minutes

before operation.

ABOUT HUMIDITY

Where you set your desired humidity levels depends on your personal comfort level,

the outside temperature and the inside temperature.

NOTE: Recent CDC tests show that the chances of flu transmission are greatly

reduced at levels of 43% humidity or higher.

You may wish to purchase a hygrometer* to measure the humidity level in your

home. See the chart of recommended humidity settings below.

*Model 1990 digital hygrometer is available for purchase by calling 1-800-547-3888.

NOTE:

External hygrometer readings and humidistat readings may differ. Humidity

levels can vary significantly even in one room.

The amount of time it takes to affect the

room humidity depends on the relative humidity of the air. In especially dry areas it

could take up to 48 hours to see humidity climb to the desired level.

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Pas de commentaire

Aircare EA1407 Manuel du propriétaire Page 6